Compaq Deskpro 2000 Series - Manual (Page 91)

5-20 Upgrading the Desktop Computer
Writer: Holly Jahangiri Saved by: Holly Jahangiri Saved date: 07/16/97 2:46 PM
Pages: 28 Words: 3162 Template: c:\msoffice\templates\comm.dot
File Name Ch5.doc Part Number 278019-002
Installing an
Additional Drive When installing a new drive you should use either the wafer
screws provided in the option kit or the extra U.S. and metric
screws stored in the front of the computer chassis for this
purpose. The same screws that are used as guide screws are
used as retainer screws to secure the drive in the drive bay.
Select the appropriate screws for the application.
✎
Metric screws have a black finish while U.S. screws have a silver
finish.
Locating the Mounting Screws
✎
Compaq strongly recommends that only an authorized service
provider replace your primary hard drive.
You must run Computer Setup after installing an additional
diskette drive. Refer to Chapter 3, “Using Compaq Software,” for
instructions.