Compaq Deskpro 2000 Series - Manual (Page 180)

E-4 System Board Jumpers and Switches
Writer: Holly Jahangiri Saved by: Holly Jahangiri Saved date: 07/03/97 10:09 AM
Pages: 6 Words: 649 Template: d:\95office\templates\commapp.dot
File Name Appe.doc Part Number 278019-002
Setting Power-On
Password Jumpers If you forget your Power-On Password, you will need to disable
it by setting the appropriate jumper on the system board.
1. Locate the appropriate jumper. For Pentium systems, this
jumper is labeled E6. For Pentium II systems, it is labeled
P2. By default, the Power-On Password is enabled,
meaning there is a plug on pins 5 and 6.
Locating the E6 Jumper on the Pentium System Board
Locating the P2 Jumper (Pins 5-7) on the Pentium II System Board
2. To disable the Power-On Password, move the plug from
pins 5 and 6 to pins 6 and 7.
3. To set a new Power-On Password, put the plug from pins 6
and 7 to pins 5 and 6, then reestablish the password using
the Security Management feature in Computer Setup.