Compaq Deskpro 2000 Series - Manual (Page 104)

6-4 Upgrading the Minitower Computer
Writer: Holly Jahangiri Saved by: ACastle Saved date: 07/25/97 2:13 PM
Pages: 28 Words: 3072 Template: c:\msoffice\templates\comm.dot
File Name Ch6.doc Part Number 278019-001
Removing the
Computer Cover
To install optional equipment, you must remove the computer
cover to gain access to the drive bays or expansion slots you
want to use.
CAUTION: Before removing the computer cover, turn off the
computer and disconnect the power cord from the electrical outlet.
To remove the computer cover, complete the following steps:
1. Turn off the computer and any external devices.
2. Disconnect the power cord from the power outlet and any
external devices from the computer.
3. Remove the thumbscrews on the rear panel of the
computer. Use a coin to loosen them if they're too tight to
loosen by hand.
4. Slide the panel to the back of the computer and pull out to
remove it.
Removing the Minitower Computer Cover
✎ The configuration label located on the bridge plate inside the
computer provides information for installing a new battery.