Compaq Deskpro 2000 Series - Manual (Page 74)

Reference Guide 5-3
Writer: Holly Jahangiri Saved By: Holly Jahangiri Saved Date: 07/16/97 2:46 PM
Pages: 28 Words: 3162 Template: c:\msoffice\templates\comm.dot
File Name Ch5.doc Part Number 278019-002
Removing the
Computer Cover To install optional equipment, you must remove the computer
cover to gain access to the drive bays or expansion slots you
want to use.
CAUTION: Before removing the computer cover, ensure that the
computer is turned off and that the power cord is disconnected
from the electrical outlet.
To remove the computer cover, complete the following steps:
1. Turn off the computer and any external devices.
2. Disconnect the power cord from the power outlet and any
external devices from the computer.
3. Remove the thumbscrews on the rear panel of the
computer. Use a coin to loosen them if they're too tight to
loosen by hand.
4. Slide the desktop computer cover backward about 1 inch
(2.5 cm); then, lift it up off the unit.
Removing the Desktop Computer Cover
✎
The configuration label located inside the computer cover provides
information for installing a new battery.