Welch Allyn TMX428CP Trackmaster Medical Treadmill - User Manual - Manual (Page 6)

Safety Information
iv
• Walk in the center of the running belt. Contact with the side rail and the moving
belt could cause injury.
• The Patient must always wear
operating the TRACKMASTER
• Place the treadmill on a
Set-up instructions in
• Check input power cord connection and location for hazardous pinch points
before use.
• Check input communications cord connection (if equipped) for proper interface
with all equipment.
• Keep all cords clear of
• Never attempt to remove the motor pan hood or do electrical repairs yourself
Repairs should
• Always unplug the TRACKMASTER
the treadmill.
• Routinely inspect the treadmill for loose parts.
• Inspect handrails and
• Always start the running belt at its slowest speed before starting your workout.
• Do not step onto belt when it is moving.
• Always slow the running belt to its minimum speed before stopping.
• Keep hands, feet, and clothing away from any moving parts.
• Verify no one is near the elevation mechanism before operating
part of the body under any part of a running treadmill.
• Never drop or insert objects into any opening.
• Never drape garme
drop objects on the belt while the
• Do not allow moisture or oils to accumulate on equipment, creating a slip hazard.
TRACKMASTER
TMX428 Owner’s Manual
Walk in the center of the running belt. Contact with the side rail and the moving
belt could cause injury.
must always wear the Stop Tether lanyard wrist strap before
operating the TRACKMASTER
®
Place the treadmill on a hard. Level and unobstructed surface. See
up instructions in Chapter 5 of this manual.
Check input power cord connection and location for hazardous pinch points
Check input communications cord connection (if equipped) for proper interface
with all equipment.
Keep all cords clear of patient to avoid trip hazards
Never attempt to remove the motor pan hood or do electrical repairs yourself
only be done by a factory authorized repair provider.
Always unplug the TRACKMASTER
®
when servicing, inspecting or cleaning
Routinely inspect the treadmill for loose parts.
Inspect handrails and ensure they will support the Patient properly.
Always start the running belt at its slowest speed before starting your workout.
Do not step onto belt when it is moving.
Always slow the running belt to its minimum speed before stopping.
Keep hands, feet, and clothing away from any moving parts.
no one is near the elevation mechanism before operating.
body under any part of a running treadmill.
Never drop or insert objects into any opening.
Never drape garments, hook-up leads, or other equipment over the side rails or
on the belt while the TRACKMASTER
®
is running.
Do not allow moisture or oils to accumulate on equipment, creating a slip hazard.
TRACKMASTER
July 2014
Walk in the center of the running belt. Contact with the side rail and the moving
lanyard wrist strap before
See Assembly /
Check input power cord connection and location for hazardous pinch points
Check input communications cord connection (if equipped) for proper interface
Never attempt to remove the motor pan hood or do electrical repairs yourself.
only be done by a factory authorized repair provider.
when servicing, inspecting or cleaning
Always start the running belt at its slowest speed before starting your workout.
Always slow the running belt to its minimum speed before stopping.
Never put any
over the side rails or
Do not allow moisture or oils to accumulate on equipment, creating a slip hazard.