Welch Allyn 1500 Patient Monitor v.1.4.X - User Manual - Manual (Page 5)

1
1
Safety
User responsibility
• The numerical and graphical results and any interpretation given must be examined
with respect to the overall clinical condition of the patient and the general recorded
data quality.
• The indications given by this equipment are not a substitute for regular checking of
vital functions.
• This monitor is only to be used by those trained in its operation or repair.
• Ensure that the personnel have read and understood these operating instructions and
in particular this “Safety” section.
• Damaged or missing components must be replaced immediately.
• It is the owner's responsibility that the valid regulations for safety and prevention of
accidents are observed.
Intended use
• The Welch Allyn ® 1500 Patient Monitor patient monitoring unit is designed for the
monitoring of vital parameters such as ECG, SpO
2
, etCO
2
, non invasive blood
pressure (NIBP), invasive blood pressure (IBP), temperature and respiration of a
patient. Cardiac output and hemodynamic calculations are also possible.
• The device is intended to be used by qualified doctors or trained medical personnel.
• The device is not suitable for transport.
• There is no danger for patients with pacemaker.
• The device is intended for the monitoring of adult, pediatric and neonate patients.
• The device is intended for the monitoring of one patient at a time.
• The device is not designed for sterile use nor is it designed for outdoor use.
• Do not use this monitor in areas where there is any danger of explosion or in the
presence of flammable gases.
• The device is classified CF. It is defibrillation protected when the original
accessories are used. However, as a safety precaution when possible, remove the
electrodes before defibrillation.
• This product is not designed for direct cardiac application.
• The arrhythmia module is not intended for use with neonatal patients.
• The ST-analysis module is not intended for use with neonatal patients.
©