Welch Allyn 1500 Patient Monitor v.1.4.X - User Manual User Manual
Page 18

14
Introduction
Welch Allyn 1500 Patient Monitor
Parameter
Settings/Submenus
Administrator
Configuration
Display of monitor ID, network settings, options, etc. This is for information
only.
Alarms
Alarm settings - silence time, suspend time, etc. This requires a password to
enter (see
System
Time and date settings and unit preference (cm/in, kg/lb). This screen also
gives the option to save the current settings as the user default settings, and
the option to display the event log screen. This screen requires a password
to enter (see
Communications, Service and Factory
These menu options are for service and factory personnel and can only be
accessed by password only. Details are given in the service handbook.
Close
Exits the setup menu.
1.
The full arrhythmia option is only viewable when the full arrhythmia option is installed.
2.
The recorder option is only viewable when the printer is installed.
3.
The parameter options will vary according to the monitor configuration and licensed options.
4.
The 12-lead resting ECG option is only viewable when the resting ECG option is installed.
5.
The hemodynamics calculations option is only viewable when the cardiac output option is installed.
6.
When the monitor is connected to an Acuity Central Station, patient information can be changed at the monitor or
by Acuity. Any changes are synchronized. The room number is defined by Acuity and cannot be changed by the
monitor. The patient information menu option is not available when an Acuity-enabled monitor is not connected to
Acuity.