Welch Allyn 1500 Patient Monitor v.1.4.X - User Manual - Manual (Page 116)

112 Settings Welch Allyn 1500 Patient Monitor
Alarm suspend
Suspend all alarms for the period specified under the Alarm settings in the Administrator
menu (see
“Administrator” on page 118 ).
Arrhythmia
Sets the Arrhythmia alarm settings, print on alarm and other options (see “Arrhythmia” on
page 50).
Alarms
Sets the upper and lower alarm limits for all parameters. If a recorder is installed, a
printout can be initiated when an alarm limit is violated.
Speaker volume
Sets the speaker volume on a scale of 1 to 10. The volume is heard when scrolling
through the values.
HR / PR tone volume
Sets the HR (from ECG), PR (from SpO
2
), or P1 beep volume on a scale of 1 to 10. The
volume is heard when scrolling through the values.
Waveform area
The waveforms displayed on the monitor are set in this menu. The waveform options will
change according to the options licensed and enabled, monitor configuration, and
parameters selected for display (see
“Defining display waveforms” on page 27).
Note A full arrhythmia option is available.
Note The alarm limits can also be set in the individual parameter settings (see
“Monitoring and Measurements” on page 39 ).
The next page option gives further
parameter limits for invasive BP.