Canon FAX-L800 - Manual (Page 356)

Canon FAX-L800 User’s Guide ENGLISH
G-10 Glossary
½ Multi TX/RX Report When you send a document to more than one
destination, the fax prints a report to show you the name and numbers of the
other parties, whether the transactions were completed or not, and errors if
any. The fax automatically prints multi-transaction reports for sending
documents to more than one destination, delayed sending documents to more
than one destination, sending documents through a relay fax to more than
one destination, and sending confidential documents to more than one
destination if the mailboxes are the same on every fax unit.
½ Relay Broadcast Report After sending a document through a relay fax, you
may receive a relay broadcast report from the fax machine that relayed the
document. This shows whether or not the document was successfully relayed
to all the final destinations. To receive a report, the other machine must be
set to print a relay broadcast report.
Resolution
The density of dots for an output device like a fax, scanner, or printer. Expressed
in terms of dots per inch (dpi). Low resolution causes font characters and
graphics to have a jagged appearance. Higher resolution means smoother curves
and angles as well as a better match to traditional typeface designs. Resolution
values are represented by horizontal data and vertical data, for example, 600 x
600 dpi.
Restricted reception
The ability of the fax unit to restrict incoming documents. With this feature
turned on, the fax unit will receive documents only from speed dialling numbers
registered in your fax unit.
Rotary pulse
A rotary-pulse or pulse dial telephone is dialled by manually rotating a dial to
send pulses to the telephone switching system. When you pulse dial, you will hear
clicks. With tone dialling, you will hear tones.
RX password
The ITU-T password set on your fax to match the ITU-T password of all
incoming documents. If your RX password matches the ITU-T password of the
incoming transmission, the document is received. If the passwords do not match,
the document is not received. The maximum length of the password is 20 digits
and may consist of numbers, spaces, asterisk (*), and pound mark (#).
S
Scanning area
The scanning area is narrower than the original document size on the entire
border around the document. Documents you send should have some margin on
the sides and the top and bottom. Anything over this margin can not be scanned
for sending.