Canon FAX-L800 - Manual (Page 184)

Canon FAX-L800 User’s Guide ENGLISH
9-10 Chapter 9 Using a Relay Network
½ Perform the procedure to register a telephone number for One-touch or
Coded Speed Dialling. (
Q4-6, 4-14) If the speed dialling buttons are already
set up, perform the procedure to change the One-touch or Coded Speed
Dialling settings. (
Q4-6, 4-14)
½ When you do the speed dialling settings, turn on the OPTIONAL SETTING
feature and select TX TYPE. Select ORIG RELAY TX and then set the
ITU-T subaddress and password. (
Q4-11, 4-19) Confirm that the other party
is set up properly to relay documents received from your fax. Your fax can
not confirm whether or not the other fax has been set up properly for
relaying a document sent from your fax.
Sending with the RELAY BROADCAST Button
Follow this procedure to send the original document for a relay broadcast with
the RELAY BROADCAST button.
You can set only one destination.
1. Set the document on the fax. (
Q6-3)
Set the document resolution, contrast, and document type. ( Q6-4)
You can also select a sender’s name with the TTI SELECTOR. (
Q6-6)
RELAY BROADCAST
2. Open both One-touch Speed Dialling panels and press RELAY
BROADCAST.
ORG RELAY TX
SELECT LOCATIONS
TEL=
3. Dial the relay units.
1
4
7
2
5
8
0
3
6
9
ABC
GHI
PQRS
JKL
TUV
M NO
WXYZ
DEF
Use regular dialling. ( Q6-7)
-or-
Press a One-touch Speed Dialling button, or press CODED DIAL followed
by a three-digit code. (
Q4-26, 4-28)