Rice Lake TS Series, Rice Lake Weighing Systems - Operation Manual - Manual (Page 80)

76 RL-TS Series Operation Manual
- When either an O8 or O9 command is executed, it returns to the state of “O0”.
(3) Set measurement mode command
C1 C2 Code (C1) Code (C2) Description Response
M 1 4DH 31H Set to Mode 1
A00: Successful completion
E01: Command error
E02: Error
M 2 4DH 32H Set to Mode 2
M 3 4DH 33H Set to Mode 3
M 4 4DH 34H Set to Mode 4
* The measurement mode to be activated by the above mode settings 1 to 4 depends on the weighing mode
currently in use.
- Relationship between weighing mode and mode setting
Mode
Weighing
machine
Parts
counting
Percentage
weighing
Unit
converting
Gravimeter
Animal
weighing
Mode 1
Weight
measuring Weight
measuring Weight
measuring Weight
measuring
Error Error
Mode 2 Gross weight
Parts
counting Percentage
measuring Coefficient
multiplying
Error Error
Mode 3
Cumulative
weight*1 Cumulative
count*1 Cumulative
percent*1 Cumulative
sum*1
Error Error
Mode 4
Display in
unit B*2 Average unit
weight
Error Error Error Error
*1: Mode 3 (M3) can be specified only when the addition function is to be used. If the addition function is not
enabled, it results in an error.
*2: If a unit is NOT specified for unit B, the balance is set for the weight measuring mode. When you specify a
mode that is not supported by the current Weighing Mode, an error is returned from the balance.
(4)
Span adjustment/test command
C1 C2 Code (C1) Code (C2) Description Response
C 0 43H 30H
Disables command
inputs.*1
A00: Successful completion
E01: Command error
E02: Operation is disabled.
E03: Cancelled by operation
E04: Abnormal completion
C 3 43H 33H
Span adjustment with
external weight
C 4 43H 34H
Span test with external
weight
*1: A span adjustment and test commands will also be disabled.
* This command takes time because the balance sends back a response after an appropriate operation is
completed.
* If set to “[Cal] key disabled” (0) in the function setting “7.CA.,” a span adjustment and test command does
not work.
66B
Response
Upon receiving an input command, the balance sends out a response.