Rice Lake TS Series, Rice Lake Weighing Systems - Operation Manual - Manual (Page 32)

28 RL-TS Series Operation Manual
15B
3.3 Measuring Percentage
With respect to the reference sample weight, the weight of a sample is shown in percentage.
A reference sample weight can be set by weighing an actual sample (setting a reference weight by weighing
an actual sample) or entering a value (setting a reference weight by entering a value).
44B
Setting a reference weight by weighing an actual sample
1
Set to the function setting mode.
(Refer to “Section 2-5: Function Setting Basics
(P.
X
22
X
).)
Press and hold the [Function] key. After “” is displayed,
release the finger.
2
Select “Percentage Weighing.” Press the [Zero/Tare] key several times to select “1.SEt 3.”
3
Save the weighing mode. Press the [Target] key.
The “percent weighing” mode is set, displaying “%.”
4
Start measuring the reference weight. Press and hold the [Function] key. After “ ” is displayed,
release the finger.
The previously-saved reference sample weight blinks.
5
Save the reference weight. Put the reference sample on the balance and then press the
[Function] key.
The reference weight is saved.
6
Weigh. The display indicates the percentage of the sample with respect
to the reference sample weight.
Pressing the [Function] key toggles the display between
percentage weight and total weight.