Rice Lake TS Series, Rice Lake Weighing Systems - Operation Manual - Manual (Page 38)

34 RL-TS Series Operation Manual
48B
Measurement
1
Set to the function setting mode.
(Refer to “Section 2-5: Function Setting Basics
(P.
X
22
X
).)
Press and hold the [Function] key. After “Func” is displayed,
release the finger.
2
Select “Gravimeter.” Press the [Zero/Tare] key several times to select “1.SEt 5.”
3
Save the weighing mode. Press the [Target] key.
The “gravimeter” mode is set, displaying “d.”
4
Set to the water temperature setting mode. Press and hold the [Zero/Tare] key.
5
Set the in-container water temperature. Set the water temperature with the following steps:
Set the water temperature starting from a higher-order digit.
1. Press the [Zero/Tare] key.
Zero blinks in the rightmost digit.
2. Select a number by pressing the [Zero/Tare] key.
Pressing the key toggles the number between 0 and 9,
and decimal point.
3. Pressing the [Function] key shifts the blinking digit to
the left, and the next lower-order digit blinks.
Set the water temperature by repeating steps 2 and 3.
- If using a liquid medium other than water, select the
medium by referring to P.
X
36
X
.
- For a liquid medium other than water, set the density.
- The value set is held even after the power is turned off.
- The acceptable range of water temperature is 0 to
99.9°C.
- Pressing the [Print] key can cancel the setting.
Reference