Rice Lake TS Series, Rice Lake Weighing Systems - Operation Manual - Manual (Page 40)

36 RL-TS Series Operation Manual
49B
Using a liquid medium other than water
1
Set to the function setting mode.
(Refer to “Section 2-5: Function Setting
Basics (P.
X
22
X
).)
Press and hold the [Function] key. After
“Func” is displayed, release the finger.
2
Select “Gravimeter.” Press the [Zero/Tare] key several times to select
“1.SEt 5.”
3
Set to the medium select mode. Press the [Function] key.
“1 1.Nd” is displayed.
4
Select “Not water.” Select “1” (Not water) by pressing the
[Zero/Tare] key and then press the [Target] key.
Now, the specific gravity in a medium other
than water can be measured.
Measure specific gravity using the steps
described in “Measurement” (P. X34X). In step
5, set the density of the used liquid medium
instead of water temperature. - The acceptable
range of liquid density is 0.0001 to 9.999 g/cm 3 .
50B
Gravimeter measurement data output
Measured specific gravity data is output to a printer as follows depending on settings:
- Before measurement
Irrespective of the setting made in the function setting “61. o.c.” (output control), pressing the [Print] key
outputs data (irrespective of whether data is stable or unstable).
- While specific gravity is displayed
Output contents and methods can be changed by the function setting “12. d.o.” (output data select) and “13.
A.o. ” (auto output).
- Output format
If [1] (specific gravity, weight, and actual water temperature or density of media) is set in the function setting
“12. d.o.” (output data select), all data is output (See the figures below).
If [0] (specific gravity only) is set in the function setting “12. d.o” (output data select), only the first and second
line values shown in the figures below are output.
If any statistical calculation is made for the printer, the values in the second line shown in the figures below will
be printed being prefixed by a serial number.
Set language for printing by the function setting “E3.P.F.” (language for printing) (1 = English/2 = Japanese).
Gravimeter measurement data output samples