Rice Lake TS Series, Rice Lake Weighing Systems - Operation Manual - Manual (Page 51)

RL-TS Series Operation Manual 47
55B
Judging by deviation values
The function setting for deviation value judgment is “24.Tp.2.”
75B
 Judging by deviation values using the method of placing actual samples on the balance
Set a reference, upper limit, and lower limit values by weighing samples.
Check that the limit function is set for judging by deviation values (refer to the previous section “Limit
function setting”).
1
Set to the mode of using actual samples. Press and hold the [Target] key. After “r.SEt”
is displayed, release the finger.
2
Weigh the reference weight sample. Place the sample serving as the reference value
and then press the [Function] key.
3
Weigh the lower limit sample. Place the sample serving as the lower limit and
then press the [Function] key.
For the case of one point setting, this operation
completes the setting saving. Go to step 5.
For the case of two point setting, “H.SEt” is
displayed.
4
Weigh the upper limit sample. Place the sample serving as the upper limit
weight on the pan and then press the [Function]
key.
The judgment value is saved and then the
balance goes back to normal display.
5
Weigh.
Place a judgment target sample on the pan.
The OK, LO, or HI result judged from the upper and
lower limit values is displayed with the “◄” indication.