Rice Lake TS Series, Rice Lake Weighing Systems - Operation Manual - Manual (Page 48)

44 RL-TS Series Operation Manual
53B
Limit function setting
First, set the limit function. Then, set limit values.
1
Set to the function setting mode.
(Refer to “Section 2-5: Function Setting Basics
(P.
X
22
X
).)
Press and hold the [Function] key. After
“Func” is displayed, release the finger.
2
Select Limit Function. Press the [Function] key several times to select
“2.SEL.”
Press the [Zero/Tare] key to select “2.SEL
2. ”
When using both the cumulate and limit
functions together, select “2.SEt 3..”
3
Set the judgment condition. Press the [Function] key several times to select
“21.Co.”
Press the [Zero/Tare] key to select the judgment
condition.
1: Always judge (even when the balance is
unstable).
2: Judge only when the balance is stable.
4
Set the judgment range to cover. Press the [Function] key several times to select
“22.Li.”
Press the [Zero/Tare] key to select the judgment
range to cover.
0: Detect when the limit is exceeded by more
than five divisions.
1: Detect both when the limit is exceeded
and when it is not reached.
5
Set the point scale to be set. Press the [Function] key several times to select
“23.Pi .”
Press the [Zero/Tare] key to select the point
scale to be set.
1: 1-point scale (OK and LO are judged.)
2: Upper and lower limits are set (HI, OK
and LO are judged).
6
Set the judgment method. Press the [Function] key several times to select
“24.tP.”
Press the [Zero/Tare] key to select the judgment
method.
1: Judge by absolute values.
2: Judge by deviation values.