Rice Lake TS Series, Rice Lake Weighing Systems - Operation Manual - Manual (Page 47)

RL-TS Series Operation Manual 43
71B
 Judgment criteria and limit value setting
A limit value can be judged with any of the following criteria:
- Absolute value: Values (limit values) including upper and lower values are set. Based on these values,
measurements are judged.
- Deviation value: A reference value is set. Measurements are judged by specifying an upper limit or a lower
limit range with respect to this reference weight.
A limit value can be entered in the following two ways:
- Putting actual samples on the balance: By weighing a sample on the balance, save the weight.
- Entering values: Set a value using the keys.
72B
 Detailed function setting
In the function setting function, the limit function can be set in detail.
When the function setting “2.SEL” is “2” or “3,” pressing the [Function] key can set the following: Set
these items as required.
Condition 21.Co. 1: Always judge.
2: Judge only when the balance is stable.
Range to Cover 22.Li. 0: Detect when the limit is exceeded by more than five divisions.
1: Detect both when the limit is exceeded and when it is not reached.
Point Scale 23.Pi. 1: 1-point scale (OK and LO are judged.)
2: Upper and lower limits are set (HI, OK and LO are judged).
Judge by 24.tP. 1: Judge by absolute values.
2: Judge by deviation values.
Buzzer for LO 25.b.1 0: The buzzer is not beeped for rank LO.
1: The buzzer is beeped for rank LO.
Buzzer for OK 26.b.2 0: The buzzer is not beeped for rank OK.
1: The buzzer is beeped for rank OK.
Buzzer for HI 27.b.3 0: The buzzer is not beeped for rank HI.
1: The buzzer is beeped for rank HI.
- Separate limit values can be saved for each weighing mode. However, limit
values of both absolute and deviation values cannot be saved in the same
weighing mode.
- Limit values can be set only in measurement mode display (Cannot be set in
other mode display such as when a cumulative value is displayed).
- Before setting limit values, as required, adjust the zero-point or set a tare range.
- If the limit value entries are not lined up in the order of magnitude, three “◄”
will be lit. Enter the values again.