Losi LOSB9556 1/8 Xcelorin ESC Manual - Manual (Page 38)

LOSB9516 Xcelorin Electronic Speed Control v1.0 Page 38
• 0% • 15%
• 4% (Default) • 20%
• 8% • 25%
• 10% • 30%
• 12%
Note: Higher motor temperatures occur with each increase in Drag Brakes.
Battery Elimination Circuit (BEC) – Can be adjusted to provide any of the
following voltages thru the receiver to the radio system. Generally 6.0V is used
to power the receiver and servo.
• 5.2V • 5.6V
• 6.0V • 6.5V
Legacy or 2.4GHz – This setting is intended to reflect what type of Radio
System you are using, i.e. Transmitter and Receiver.
Default is 2.4GHz because there are many of these systems in use.
If you use a Legacy system
, then you can select this setting (27MHz, 40MHz, or 75MHz).
The Electronic Speed Control internal switching rate is increased with the 2.4GHz selection
and may cause interference with Legacy Radio Systems.