Losi LOSB9556 1/8 Xcelorin ESC Manual - Manual (Page 28)

LOSB9516 Xcelorin Electronic Speed Control v1.0 Page 28
General Tab: Here you will find the following configuration settings:
Battery Type and Cutoff Voltage, Brake/Reverse, Motor Timing, Initial Acceleration, Percent
Drag Brake, ESC operating mode, Deadband adjustment, Braking Percentage, Throttle
Limit, Reverse Throttle Limit and Motor Rotation. All changes are done at your own risk.
Throttle Tab: Only recommended for more experienced Electronic Speed Control users.
You can remap the throttle profile from the default linear line. Changes are done at your
own risk.
Brake Tab: Only recommended for more experienced Electronic Speed Control users as
well. You can remap the brake profile from the default linear line. Changes are done at
your own risk.
About Tab: Here you will see the Setup software version installed, and date of last
update. This will be helpful information should you have questions or support concerns.
Connection: This section is displayed on every Tab. There are two icons; one for the USB
connection, the other indicates the Electronic Speed Control connection. They are RED in
color when disconnected and GREEN on connection.
Note: Without an understanding of a specific function and reason, it is not recommended
that you make changes to the default configuration. There have been defaults selected as
a direct result of our testing, which were used to establish these settings. Changing of the
configuration will be at your own risk.
Read Settings: Use of this button will read the current Electronic Speed Control (ESC)
configuration and present it on the current tabbed page only.
Send Setting: Use of this button will send (write) the current selected configuration to
the ESC for the current tabbed page only.