Losi LOSB9556 1/8 Xcelorin ESC Manual - Manual (Page 13)

LOSB9516 Xcelorin Electronic Speed Control v1.0 Page 13
6. Connect the Signal wire to the top of the 8QPC, ensure it is connected
correctly.
7. Pay close attention to the ESC LEDs and you will notice the Red LED flash,
and on the 8QPC the Red LED will come on. If you do not notice the ESC Red
LED flash, you can unplug the Signal wire from the 8QPC and reconnect again
to verify the operation of the Red LEDs. Once you see the ESC Red flash and
the 8QPC turn on Red, the ESC has accepted the programming.
8. Disconnect the Signal wire from the 8QPC, turn off the power switch.
9. Reconnect the signal wire into the receiver.
10. The ESC has been updated and you are ready.
Note: If you should happen to lose any of your jumpers they are the
same jumpers used with computers and easily obtained at a computer
store.
ESC Warning LEDs
• If the Battery low voltage cutoff (LVC) is reached the Red LED will blink.
• The Red LED will automatically stop blinking should the battery voltage
recover above the chosen low voltage cutoff.
• If the ESC has detected a thermal overload, the Yellow LED will blink. Let the
ESC cool down.