Losi LOSA9155 - Manual

LOSA9155
Losi
™
, Quick Change Engine Mount
Installation Guide:
1. Disconnect the throttle linkage, fuel and pressure
lines from engine and pipe.
2. Remove the engine and exhaust system by
removing the four engine mount screws, and one
pipe mount screw.
3. Remove both engine mounts from the engine.
4. Apply Loctite
®
to threads of the supplied 5-40 x ½
cap head screws and washers. Install an engine top
block to each side of the engine with the arrows
pointing towards the clutch. Only thread each
screw in a few turns.
5. Place the engine assembly on the base mount and
fully tighten the screws installed in the previous
step, this will ensure the locating pins are correctly
aligned.
6. Attach the Top Mount to the Base with the supplied
5-40 x ½ cap-head screws; apply Loctite
®
to the
screws threads.
7. Place the engine assembly into the chassis and re-
install the engine and pipe mounting screws. Set
the proper gear mesh before fully tightening the
screws.
8. Re-attach the throttle linkage, fuel and pressure
lines.
9. Check for proper throttle and brake linkage
adjustment.
***Note***
(Installing the top block with the arrows pointing
away from the clutch will move the engine forward
2mm, allowing correct alignment of aftermarket and
standard 3-shoe clutches). Do not install the engine
in the forward position, when using the standard 4-
shoe clutch damage to the fuel tank will occur.
This engine mount can not be used with engines
equipped with a pull or spin start systems.
PN: 800-0326
2007 Losi, a division of Horizon Hobby, Inc
A6240
5-40 x 1/2
A6215
Ball Stud
Washer
A1956
Top Block
A1955
Base Mount
A6240
5-40 x 1/2
www.losi.com