Losi LOSB9464 - Manual

Xcelorin 18 th Sensored Brushless Motor Instructions
Xcelorin 18 th Sensored Motors v1.1
◊ LOSB9464 18.5T
Thank you for purchasing the Losi® Xcelorin™ Sensored Motor. This motor will provide you the benefit of the
latest in brushless sensored motor technology. We believe it will be to your benefit to take the time and effort to
read these instructions. We are confident you will be satisfied with the performance of the Xcelorin Sensorless
Motor.
Losi/Horizon Support
If you have any questions concerning operation of your Xcelorin Motor, please call Horizon customer support at 1
877 504 0233. For international customers, please see contact information below. You are welcome to call us with
any support issue or question you may have.
Safety Precautions and Warnings:
• Please read instructions before operating.
• Do Not use this motor with a Schottky Diode.
• Avoid over-gearing by monitoring temperature.
• Operating temperature should not exceed 165F (74C) degrees.
• Do not over-tighten the motor mounting screws. Damaged threads are not covered under warranty.
• Ensure the motor screws do not go into the motor more than 0.138 in (3.5mm).
Specifications:
LOSB9464
Sensored Yes
Rotor Magnet
Sintered
RPM @ 7.2V 20160
RPM per Volt 2800
Power (W) 150
Efficiency 94%
Common Specifications:
Precision Ball Bearings
Compatible with both 2S and 3S LiPo batteries, and NiMH batteries from 6- to 8-cells
Weight: 2.2 oz (63g)
Installation and Maintenance:
• Make certain the 3mm motor screws being used do not extend into the motor more than 0.138 in
(3.5mm). Otherwise, you can internally damage the stator windings.
• For the sensored motor the wiring must be in sequence or you will damage either the Electronic Speed
Control (ESC) or the motor itself. Most popular ESCs use standard colors of wire to make the connection
easier motor to motor. These colors are currently Blue, Yellow and Orange, when looking at the plastic end
cover with the tabs to the top. The wires will connect from Left to Right in this sequence: Blue to the left,
Yellow center, and Orange on the right.
• Do not over-tighten the motor screws.
• Brush off dirt and dust frequently from the bearings. Place a drop of oil on each bearing at the same time.
Gearing Suggestions:
Losi Mini Rock Crawler
15T pinion