Losi LOSB9432 User Manual
Xcelorin 10, Sensorless brushless motor instructions
Xcelorin 10
th
Sensorless Brushless Motor Instructions
Xcelorin 10
th
Sensorless Motors v1.0
LOSB9430 4800Kv ◊ LOSB9431
6400Kv
◊ LOSB9432
7500Kv
◊
Thank you for purchasing the Losi™ Xcelorin™ sensorless motor. This motor will provide you the
benefit of the latest in brushless technology.
We believe it will be to your benefit to take the time and effort to read these instructions.
We are confident you will be satisfied with the performance of the Xcelorin Sensorless Motor.
Losi/Horizon Support
If you have any questions concerning operation of your Xcelorin Motor, please call Horizon customer
support at 1 877 504 0233.
You are welcome to call us with any support issue or question you may have.
Safety Precautions and Warnings:
•
Please
r
ead instructions before operating.
•
Do Not use a Schottky Diode with this motor.
•
Avoid over-gearing by monitoring temperature.
•
Operating temperature should not exceed 165F – 175F (74C – 80C) degrees.
•
Do Not over tighten the motor mounting screws. Damaged threads are not covered under
warranty.
•
Ensure the motor screws do not go into the motor more than 0.180 in (4.5mm).
Specifications:
LOSB9430 LOSB9431 LOSB9432
Sensorless
Construction
Yes Yes Yes
Rotor
Magnet
Sintered Sintered Sintered
RPM @ 7.2V
34,560
46,080
54,000
RPM per Volt
4800
6400
7500
Power
(W)
500 580 630
Efficiency
90% 88% 85%
Common Specifications:
Precision Ball Bearings
Compatible with both 2S and 3S LiPo batteries, and from 4 to 12 cells
Weight: 6.35 oz (180 g)
Installation and Maintenance:
•
Make certain the 3mm motor screws being used do not extend into the motor more than
0.18 in (4.5mm). Otherwise, you can internally damage the stator windings.
•
With a Sensorless motor you will need to connect the 3 ESC motor leads from the Electronic
Speed Control (ESC), one to each tab.
•
If the motor runs in the opposite direction desired, unplug any two motor wires, reverse the
location and plug back together.
•
Do not over-tighten the motor screws.
•
Brush off dirt and dust frequently from the bearings. Place a drop of oil on each bearing at
the same time.