Losi LOSB9463 User Manual
Xcelorin 18, Sensorless brushless motor instructions
Xcelorin 18
th
Sensorless Brushless Motor Instructions
Xcelorin 18
th
Sensorless Motors v1.0
LOSB9460 6000Kv
◊ LOSB9461
7400Kv
◊
LOSB9462 8200Kv
◊ LOSB9463
9400Kv
◊
Thank you for purchasing the Losi™ Xcelorin™ sensorless motor. This motor will provide you the
benefit of the latest in brushless technology.
We believe it will be to your benefit to take the time and effort to read these instructions.
We are confident you will be satisfied with the performance of the Xcelorin Sensorless Motor.
Losi/Horizon Support
If you have any questions concerning operation of your Xcelorin Motor, please call Horizon customer
support at 1 877 504 0233.
You are welcome to call us with any support issue or question you may have.
Safety Precautions and Warnings:
•
Please
read
instructions before operating.
•
Do Not
use this motor with a Schottky Diode.
•
Avoid over-gearing by monitoring temperature.
•
Operating temperature should not exceed 165F (74C) degrees.
•
Do Not over-tighten the
motor mounting screws. Damaged threads are not covered under
warranty.
•
Ensure the motor screws do not go into the motor more than 0.138 in (3.5mm).
Specifications:
LOSB9460 LOSB9461 LOSB9462 LOSB9463
Sensorless
Construction
Yes Yes Yes Yes
Rotor
Magnet
Sintered Sintered Sintered Sintered
RPM
@
7.2V
43,200 53,280 59,040 67,680
RPM
per
Volt
6000 7400 8200 9400
Power
(W)
135 150 170 180
Efficiency
85% 83% 81% 80%
Common Specifications:
Precision Ball Bearings
Compatible with both 2S and 3S LiPo batteries, and NiMH batteries from 4
-
to 12
-
cells
Weight: 1.87 oz (53g)
Installation and Maintenance:
•
Make certain the 3mm motor screws being used do not extend into the motor more than
0.138 in (3.5mm). Otherwise, you can internally damage the stator windings.
•
With a Sensorless motor you will connect the 3 motor leads, from the Electronic Speed
Control (ESC), one to each motor connector.
•
If the motor runs in the opposite direction desired, unplug any two motor wires, reverse the
location and plug back together.
•
Do not over
-
tighten the motor screws.
•
Brush off dirt and dust frequently from the bearings. Place a drop of oil on each bearing at
the same time.