Losi LOSB9556 1/8 Xcelorin ESC Manual User Manual
Page 33
LOSB9516 Xcelorin Electronic Speed Control v1.0 Page 33
When using any Lithium or M1 (A123) batteries, they must not be discharged to less
than 3.0V per cell.
•
No Cutoff
The choice is not available and NOT recommended when using any
type of Lithium battery.
•
Customize Voltage Cutoff (for Lithium Batteries) after selecting the number of cells
(2 thru 5) the default voltage is displayed. For example, you select a 2S battery; the
default cutoff voltage will be 6.0V (# of cells multiply by 3.0V). You may raise this to
protect your expensive batteries in 0.1V increments up to 7.0V. For 4S, the default
cutoff is 12.0V and you may increase these values but NOT decrease.
Brake/Reverse – This is only to determine if reverse is to be enabled or not.
You will find in racing, most tracks will not allow racing with reverse enabled.
•
Forward w/o Reverse: (DEFAULT)
This is a Race setting - Reverse is disabled.
•
Forward with pause then Reverse
General bashing around (FUN) or racing if reverse is allowed for the event. The Electronic
Speed Control requires 2 seconds of continuous neutral from the transmitter prior to
allowing reverse to operate.