2 mac address sub-menu, 3 subnet mask sub-menu, 4 gateway address sub-menu – Kontron KTC5520-EATX User Manual
Page 94
78
www.kontron.com
5.1.7.1.2
MAC Address sub-menu
5.1.7.1.3
Subnet Mask sub-menu
5.1.7.1.4
Gateway Address sub-menu
Feature
Options
Description
Setup Help
Channel Number
Each interface has a channel number that is
used when configuring the channel and for
routing messages between channels.
The channel number assignments are
described in IPMI Specification 1.5, table 6-1.
Enter Channel Number
for SET LAN Config
Command.
Proper value below 16.
Channel Number Status
Valid or Invalid
Display Valid if IPMC support LAN Channel.
N/A, display only.
Current MAC Address
xx.xx.xx.xx.xx.xx
Display the current MAC Address stored in IPMI
NVRAM for IPMI LAN.
N/A, display only.
Feature
Options
Description
Setup Help
Channel Number
Each interface has a channel number that is
used when configuring the channel and for
routing messages between channels.
The channel number assignments are
described in IPMI Specification 1.5, table 6-1.
Enter Channel Number
for SET LAN Config
Command.
Proper value below 16.
Channel Number Status
Valid or Invalid
Display Valid if IPMC support LAN Channel.
N/A, display only.
IP Address Source
Static
DHCP
Configure Subnet Mask from DHCP.
Select IP Address
Source:
Static or DHCP
Current Subnet Mask
xxx.xxx.xxx.xxx
Display the current Subnet Mask configuration
stored in IPMI NVRAM for IPMI LAN.
N/A, display only.
Subnet Mask
Enter
This allows setting of a Subnet Mask for LAN
configuration.
Enter for Subnet Mask
Configuration.
Feature
Options
Description
Setup Help
Channel Number
Each interface has a channel number that is
used when configuring the channel and for
routing messages between channels.
The channel number assignments are
described in IPMI Specification 1.5, table 6-1.
Enter Channel Number
for SET LAN Config
Command.
Proper value below 16.
Channel Number Status
Valid or Invalid
Display Valid if IPMC support LAN Channel.
N/A, display only.
IP Address Source
Static
DHCP
Configure Gateway address from DHCP.
Select IP Address
Source:
Static or DHCP
Current Gateway Address
xxx.xxx.xxx.xxx
Display the current Gateway configuration
stored in IPMI NVRAM for IPMI LAN.
N/A, display only.
Gateway Address
Enter
This allows setting an Gateway IP Address for
LAN configuration.
Enter for Gateway
IP Address
Configuration.