Kontron KTC5520-EATX - Manual (Page 45)

29 KTC5520/EATX
www.kontron.com
4.6.3 Users
This section allows managing the authorized users. A maximum of five (5) users can be set. All users can be
enabled or disabled. Privilege levels are defined in the table below.
Table 4-2: Privilege Level Description
The User ID 1 is a user without name and password. This user can be enabled or disabled and has a privilege
level set to “User” by default.
The User ID2 is the admin user. It has the “Administrator” privileges.
The User ID3 to User ID5 are configurable. By default they are not set to “Enable”.
4.7 Logout
This button allows a safe logout of the management interface.
An automatic logout will be done after 300 seconds of inactivity.
Privilege Levels Description
Administrator
All BMC commands are allowed, including configuration settings. An Administrator can even execute
configuration commands that would disable the channel that the Administrator is working on.
Operator
All BMC commands are allowed, except for configuration settings which can change the behavior of the out-
of-band interfaces. For example, Operator privilege does not allow the capability to disable individual
channels, or change user access privileges.
User
Only “basic” commands are allowed. These are primarily commands that read data and retrieve status.
Commands that can be used to alter BMC configuration, write data to the management controllers, or
perform system actions such as resets, power on/off, and watchdog activation are locked.
Callback
This may be considered the lowest privilege level. Only commands necessary to support initiating a callback
are allowed.
No Access No access is given to this user.