Kontron KTC5520-EATX - Manual (Page 84)

68 KTC5520/EATX
www.kontron.com
5.1.4.7 Remote Access Configuration sub-menu
Feature Options Description Setup Help
Remote Access
Disabled
Enabled
Configures console redirection.
Disabling remote access will hide all related
features in this sub-menu.
Select Remote Access
type.
Serial port number
COM1
COM2
Configures serial port for console redirection.
Also used for Headless operation mode
through ACPI.
Select Serial Port for
console redirection.
Make sure the selected
port is enabled.
Base Address, IRQ IO, IRQ
Displays the hardware address of the COM port
used for the console.
N/A, display only.
Delay to add for display
No Delay
Delay 1 sec
Delay 2 sec
Delay 4 sec
Add some delays in
seconds to help display
different screen
information.
Serial Port Mode
115200 8,n,1
57600 8,n,1
38400 8,n,1
19200 8,n,1
09600 8,n,1
Configures the serial Baud rate for the serial
ports.
8 data bits, no parity and 1 stop bit parameters
are fixed.
Select Serial Port
settings.
Flow Control
Hardware
Software
None
Configures flow control for console redirection
for both serial ports.
Select Flow Control
for console
redirection.
Redirection After BIOS
POST
Disabled
Boot Loader
Always
Selects how the serial redirection done by the
BIOS will operate after the POST.
Disable: Turns off the
redirection after POST
Boot Loader:
Redirection is active
during POST and
during Boot Loader.
Always:
Redirection is always
active.
(Some OSs may not
work if set to Always)
[Enabled] - keep it
[Disabled]- deactivate
Terminal Type
ANSI
VT100
VTUTF8
Configures the type of console emulation used
for both serial ports.
Select the target
terminal type.
VT-UTF8 Combo Key
Support
Disabled
Enabled
VT-UTF8 adds escape sequences for F1 to F12
and most other control keys on a keyboard.
Enable VT-UTF8
Combination Key
Support for ANSI/VT100
terminals.
Sredir Memory Display
Delay
No delay
Delay 1 Sec
Delay 2 Sec
Delay 4 Sec
Allows additional delay during POST to give
time to display memory information by the
terminal software.
Gives the delay
in seconds to
display memory
information
Note:
BIOS doesn't change automatically the baud rate of the console redirection over LAN. The following
commands must be executed on the KTC5520/EATX.
#ipmitool -H [ip address] -I lanplus -C 1 -U [user name] -P [password] sol
set non-volatile-bit-rate [serial port speed]
#ipmitool -H [ip address] -I lanplus -C 1 -U [user name] -P [password]sol
activate