Kontron AM4901 IPMI User Manual
User guide, Ipmi firmware user guide
This manual is related to the following products:
Table of contents
Document Outline
- Revision History
- Imprint
- Disclaimer
- Table of Contents
- List of Tables
- 1. Introduction
- 2. Operation
- 3. System Initialization and Operation
- 4. System Management
- 5. User Interfaces on the MCH Front Panel
- 6. Configuration Parameters
- 7. Sensors
- 8. Supported OEM IPMI Commands and Command Extensions
- 8.1 Extended Standard Commands
- 8.2 Kontron OEM Commands
- 8.2.1 Write Switch Register
- 8.2.2 Read Switch Register
- 8.2.3 Set Fan Speed Parameter
- 8.2.4 Get Fan Speed Parameter
- 8.2.5 Set Permanent Power Parameter
- 8.2.6 Get Permanent Power Parameter
- 8.2.7 Set Slot Presence Parameter
- 8.2.8 Get Slot Presence Parameter
- 8.2.9 Set Common Options Parameter
- 8.2.10 Get Common Options Parameter
- 8.2.11 Set Slot Options Parameter
- 8.2.12 Get Slot Options Parameter
- 8.2.13 Clear All NV Parameters
- 8.2.14 Set Password
- 8.2.15 Set Event Driven Temperature Control Parameter
- 8.2.16 Get Event Driven Temperature Control Parameter
- 8.2.17 Set Environmental Options Parameter
- 8.2.18 Get Environmental Options Parameter
- 8.2.19 Set Priority Options Parameters
- 8.2.20 Get Priority Options Parameters
- 8.2.21 Set Activation Options Parameters
- 8.2.22 Get Activation Options Parameters
- 8.2.23 Set Current Options Parameters
- 8.2.24 Get Current Options Parameters
- 8.2.25 Set Fclock Options Parameter
- 8.2.26 Get Fclock Options Parameter
- 9. Basic Installation and Upgrade of the MCH Firmware
- 10. Special Failure Situations
- 11. Peculiarities and Restrictions for Releases