Kontron AM4901 IPMI - Manual (Page 64)

IPMI Firmware User Guide AM5901/AM4901
Page 64 ID: 1035-8760, Rev. 3.0
8.1.3 Manufacturing Test On Command
In the table below, only the Kontron extension/modification of the standard command is provid-
ed. Refer to the IPMI specification for the complete description of the command.
COMMAND LUN NetFn CMD
Manufacturing Test On Command 00h App = 06h 05h
REQUEST DATA
Byte Data Field
1:4 Password = 0xb4 0x90 0x91 0x8b
5 Mode = 0x80 = Board test.
The bits in byte 6 are valid only for the MCH
6 Test options: switch on or off test disturbing activities
[0] = 1 = Standard access to IPMBs is off
[1] = 1 = Standard access to the I2C temperature device is off
[2] = 1 = Standard sensor readings are off
[3] = 1 = No standard MCH device is active (temp. control, power control etc.)
[0:3] = 0 = All kinds of hardware access by the standard firmware is allowed, i.e. the test
mode is completely disabled. Use this to disable the board test again.
RESPONSE DATA
Byte Data Field
1 Completion code