Kontron AM4901 IPMI - Manual (Page 4)

Page 4 ID: 1035-8760, Rev. 3.0
IPMI Firmware User Guide AM5901/AM4901
3.7 Anomalous Behavior and Status Indications ............................................. 23
3.8 LEDs .......................................................................................................... 23
3.8.1 Blue Hot Swap LED .......................................................................... 23
3.8.2 Out Of Service (OOS) LED ............................................................... 23
3.8.3 Health LED ........................................................................................ 23
3.9 Eventlog ..................................................................................................... 24
3.10 Error Variables, Error Indication, and Error Clearing ................................. 24
4. System Management ................................................................................... 26
5. User Interfaces on the MCH Front Panel ................................................... 28
5.1 Command Line Interface (CLI) .................................................................. 28
5.1.1 Interface Parameters ......................................................................... 28
5.1.2 CLI Command List ............................................................................ 28
5.2 Ethernet Management Port ........................................................................ 36
5.2.1 IPMI Over LAN (IOL) for Invoking IPMI Commands ......................... 37
5.2.2 Serial Over LAN (SOL) for CLI over LAN .......................................... 37
5.2.3 Virtual LAN (VLAN) ........................................................................... 38
6. Configuration Parameters ........................................................................... 39
6.1 Common Options (copts) ........................................................................... 39
6.1.1 Defaults ............................................................................................. 42
6.2 Environmental Options (eopts) .................................................................. 43
6.2.1 Defaults ............................................................................................. 47
7. Sensors ......................................................................................................... 52
7.1 MCH Sensors ............................................................................................ 52
7.2 OEM (Kontron) Sensors ............................................................................ 58
7.3 MCH Analog Sensor Thresholds ............................................................... 60
7.4 Sensor Data Record Repository ................................................................ 61
8. Supported OEM IPMI Commands and Command Extensions ................. 62
8.1 Extended Standard Commands ................................................................. 62
8.1.1 Get Device ID Command with Kontron OEM Extensions ................. 62