Kontron AM4901 IPMI - Manual (Page 29)

AM5901/AM4901 IPMI Firmware User Guide
ID: 1035-8760, Rev. 3.0 Page 29
activopts Shows which activation and deactivation mode is currently
selected (auto or manu or off). When manu mode is selected the
manual parameters are displayed as well.
R
auto|manu|off Sets the activation and deactivation management mode for
selection of the delays being used during the activation and
deactivation of the AMC modules.
auto: Follows the data in the FRU record “MicroTCA Carrier
Activation and Power Management record”.
manu: Use delays as being defined in the manu parameters
below.
off: No activation and deactivation delays will be used.
manu
time>
…
Sets the manual activation mode and the parameter values for
manual mode.
“max. allowed ready time” defines the maximum time (hex [1s])
that will be waited until a module is active before activating the
next module.
“delay after slot x” defines which time (hex [100ms]) will be
waited after the activation or deactivation of a module has
ended before the next module will be processed.
clearerror Clears the runtime errors in the error variable and shows the
present state of the error variable using command ‘showerror’ R
cmds Print list of commands UR
copts Display the current common options as one hexadecimal num-
ber and as a sequence of hexadecimal numbers R
(hex)> Set all common options as one hexadecimal number R
Set one common option. For the related option designator refer
to the result of command 'copts'. Only the first four characters of
the designators being listed are used as option designators.
Note: For 'supprAM4901ErrorBeforeBoardRevR12' use 'supP'
instead of 'supp'. For the option values refer to chapter 'common
options'. R
Table 6: CLI Command List
Command Parameters Description
User
or
Root