Kontron AM4901 IPMI - Manual (Page 40)

IPMI Firmware User Guide AM5901/AM4901
Page 40 ID: 1035-8760, Rev. 3.0
Singular changes of options (bit-wise) are not possible. All Common Options must be read
each time, modified where required, and then re-written.
The following table provides a listing of all Common Options.
Table 7: Common Options List
Bits Common Options Format Description
Set
Automatic
/
Manual
31 locked bool 1 = All other Common Options are locked
against automatic modifications. Only
manual changes by e.g. CLI command
‘copts’ are possible.
0 = Not locked
M
30 suppressRedLEDForEvent-
ProcessingError bool 1 = suppress the red health LED in cases
where only an event log processing
error is active. This error occurs nor-
mally only if the event log is full.
Note: The event log can be cleared by a
standard IPMI command.
M
29:24 --- --- Reserved ---
23:21 tempCtrlDevice --- ID of the used Temperature Control Strategy
>1 = Undefined ID
1 = Temperature control is driven by tem-
perature events. Automatic Fan Speed
0 = No automatic temperature control. Fan
Speed can be set manually by CLI com-
mand ‘fan’
A, M
20 processPwrShutdownEvent bool Some older IPMI firmware versions for AMC
modules send misleading Power Shut Down
events at start time. This behaviour can prevent
the activation of the AMC module.
1 = Process all Power Shut Down Events at
any time.
0 = Suppress the processing of Power Shut
Down Events when not waiting for them
e.g. when waiting for Quiesce state dur-
ing deactivation. Please note that this
suppression might prevent the deactiva-
tion of a module after a simple OS shut
down because in this case a Power Shut
Down will be simulated.
A, M
19 --- --- Reserved ---