Kontron AM4901 IPMI - Manual (Page 86)

IPMI Firmware User Guide AM5901/AM4901
Page 86 ID: 1035-8760, Rev. 3.0
10. Special Failure Situations
10.1 Special Error Situations
The following information provides assistance to users for special error situations:
• Health LED is red: refer to chapter 3.8.3.
• AMC module does not activate: cause: slots improperly configured: refer to chapter 3.1.1,
or the AMC's FRU data does not contain a Current Requirement Record
• MCH FRU data not readable: cause: Common Options corrupted: refer to chapter 6.1.1,
re-enter and protect
• Backplane FRU data not readable: Environmental Options corrupted: refer to chapter
6.2.1, re-enter and protect
• Timeout during module activation occurs (message "WARNING: ACTIVATION
TIMEOUT FOR MODULE IN SLOT… CHECK MODULE AND PARAMETERS!"). Please
refer to CLI command 'activopts', chapter 5.1.2 CLI Command List.
• An AMC module can't be activated because it does not contain a Current Requirement
Record in its FRU data or the current value is 0. Message "CURRENT REQUIREMENT
RECORD MISSING FOR MODULE IN SLOT… OR VALUE IS 0." Or message "NO
CARRIER POWER POLICY RECORD FOUND".
• An AMC module can't be activated because there is no related backplane FRU data.
Message "CARRIER ACTIVATION AND CURRENT DESCRIPTOR MISSING FOR
SLOT…".
• The MCH resets continuously after powering up. Probably the MCH runs in a rack of type
OM6060 or OM6040D. Please disable the Management Ethernet port. Refer to chapter
"11. Peculiarities and Restrictions for Releases" for R31.
10.2 Error Messages when Storage Overflow Occurs
When the backplane offers more data than the MCH is able to store, then one of the following
error messages may occur. This should not occur in "well known" racks. Please note that it
might be impossible to maintain all inserted AMC modules. The "0xnn" values indicated are the
currently implemented limits.
ERROR: CARRIER_PTP_CONNECTIVITY_RECORD: Max PtP Res Descr
exceeded >= 0x22
WARNING: CARRIER_PTP_CONNECTIVITY_RECORD: Max Port Descr
exceeded = 0x21
WARNING: CARRIER_ADDRESS_TABLE_RECORD: Max Carrier Table
exceeded = 0x10
WARNING: AMC_PTP_CONNECTIVITY_RECORD: Max AMC Channel Descr
exceeded = 0x16
WARNING: AMC_PTP_CONNECTIVITY_RECORD: Max AMC Link Descr
exceeded = 0x22