Kontron AM4901 IPMI - Manual (Page 39)

AM5901/AM4901 IPMI Firmware User Guide
ID: 1035-8760, Rev. 3.0 Page 39
Further, the IP address of "eth1" must be removed:
and a valid ipaddress for eth1.3 specified and set up:
A few seconds later, invoking the command:
should indicate that the virtual LAN 3 is now available.
To use the virtual LAN 3, invoke for example:
To switch off the VLAN support in the MCH, invoke for example:
or using the CLI, enter:
To re-establish a virtual LAN, repeat the above as required.
6. Configuration Parameters
6.1 Common Options (copts)
The first time the MCH is activated, the Common Options are automatically set to default values
corresponding to the MCH board type. These options can be adapted by the user as necessary
using the CLI command “copts” and the OEM IPMI commands “CmdGetCommonOptionsPat-
erameter” and the “CmdSetCommonOptionsParameter”. All modifications remain in effect
even after resetting or powering-down as long as when the MCH is re-activated no new board
type is recognized or the non-volatile parameters of the MCH are lost.
Manual adaption of the options can be expedient for example in the following cases:
• the MCH hardware is an AM4901 and the board revision is
Here the options bit 0 (“supprAM4901ErrorBeforeBoardRev12”) should be set to sup-
press the issuing of an error message.
• the automatic temperature regulation is to be deactivated via the parameter:
tempCtrlDevice = 0
• the modified options are to be permanently protected against automatic adaption.
This protection is achieved by setting the options bit 31 (“locked”).
ifconfig eth1 0.0.0.0
ifconfig eth1.3 192.168.168.212 up
arp -n
ipmitool -I lan -H 192.168.168.211 -U admin -P admin lan print 1
ipmitool -I lan -H 192.168.168.211 -U admin -P admin lan set 1
vlan id off
lan set 1 vlan off