Kontron AM4901 IPMI - Manual (Page 32)

IPMI Firmware User Guide AM5901/AM4901
Page 32 ID: 1035-8760, Rev. 3.0
fan Set the fan speed level to 0…f (min…max). Please note that the
manual setting is only possible if the temperature control is
switched off R
Display the real fan speed [rpm] R
help Print online help of all commands with parameter descriptions UR
lan print 1 Display all current LAN parameters for the management port R
set 1 macaddr
Set the management port’s MAC address (x = hex) R
set 1 ipaddr Set the management port’s IP address (x = dec) R
set 1 netmask Set the management port’s subnet mask (x = dec) R
set 1 vlan Set the vlan ID x (x = dec, 0 < x < 4095) R
set 1 vlan off Set the vlan support off R
set 1 access on Set the management port channel access mode to on R
set 1 access off Set the management port channel access mode to off R
led Access to Carrier Management LEDs
on|off MCMC (on) or Switch (off) controls CMLEDs 1..13 R
set|clr Set or clear a single LED (requires 'led on').
: 1 - d = LED number (hex) R
all Set or clear all LEDs (requires 'led on').
: 0 - 2ffe One bit per CMLED 1..13
0 All LEDs off
2ffe All LEDs on R
login Log in using the current password to be able to use root (R)
commands. If no password was defined until now no login is
needed. UR
logout From now on no root (R) commands can be used if a password
is currently defined. R
md [] Display memory contents.
in hex to define start of display; default is end of last dis-
play UR
Table 6: CLI Command List
Command Parameters Description
User
or
Root