Kontron AM4901 IPMI - Manual (Page 77)

AM5901/AM4901 IPMI Firmware User Guide
ID: 1035-8760, Rev. 3.0 Page 77
8.2.21 Set Activation Options Parameters
This command sets the activation and deactivation parameters and the related common op-
tions parameters and saves them to EEPROM.
Command LUN NetFn CMD
CmdSetSlotActivConfigParameter (internal name) 00h OEM = 3Eh 36h
REQUEST DATA
Byte Data Field
1 Kontron IANA LSB
2 Kontron IANA byte 2
3 Kontron IANA MSB
4 activConfigMode (refer to common options)
0=AUTO: Use parameters from back plane FRU data “MicroTCA Carrier Activation and
Power Management record”
1=MANU: Use Slot activation/deactivation parameters (refer to below)
2=OFF: No delays during activation/deactivation used.
5 allowReady [s]
When a module needs more than this time for getting ready (M3) then the activation
sequence is continued.
6:8 reserved=0
9:9+12 Delays before processing next slot [100ms] for 12 slots. Beginning with slot 1. Delays for
not existing slots e.g. 7…12 are void. Maximal value is 3fh i.e. 6.3s.
RESPONSE DATA
Byte Data Field
1 Completion Code
2 Kontron IANA LSB
3 Kontron IANA byte 2
4 Kontron IANA MSB