Kontron AT8050 - Manual (Page 130)

Software Setup
114 AT8050
www.kontron.com
4 BIOS mention: "Please wait, invoking SAS Configuration Utility..."
"***LSI Corp Configuration Utility will load after initialization***"
5 Select "SCSI:LSI MPI Boot Support" in Popup menu
The menu is now available.
5.2.4 BOOT Menu POP-UP
The BOOT Menu POP-UP expands your boot options by letting you choose your boot device, which could be a
hard disk, floppy disk, CDROM, Flash Disk, SCSI or LAN. You can select your boot device in Setup, or you can
choose a different device each time you boot during POST by selecting your boot device in the Boot device
(or from a Console Redirection terminal).
5.3 Console Redirection (VT100 Mode)
The VT100 operating mode allows remote setup of the board. This configuration requires a remote terminal
that must be connected to the board through a serial communication link.
5.3.1 Requirements
The terminal should emulate a VT100 or an ANSI terminal. Terminal emulation programs such as Telix©,
HyperTherminal(Windows), minicom(Linux) or ProComm©(Windows) can also be used.
5.3.2 ANSI and VT100 Keystroke Mapping
Up [A
Down [B
Right [C
Left [D
Home [H
End [K
F1 OP
F2 OQ
F3 OR
F4 OT