Kontron AT8050 - Manual (Page 100)

Software Setup
84 AT8050
www.kontron.com
5. Software Setup
5.1 AMI BIOS Setup Program
All relevant information for operating the board and connected peripherals is stored in the CMOS memory
backed-up by a supercap or in the main BIOS flash and EEPROM. The latest is the default configuration.
5.1.1 Accessing the BIOS Setup Utility
The system BIOS (Basic Input Output System) provides an interface between the operating system and the
hardware of the AT8050. It uses the AMI Setup program, a setup utility in flash memory that is accessed by
pressing the (or from a console redirection terminal) key at the appropriate time during system
boot. This utility is used to set configuration data in CMOS RAM.
To run the AMI Setup program incorporated in the ROM BIOS:
• Turn on or reboot the system.
• When you get the following messages, hit key to enter SETUP.
AMIBIOS(C)2010 American Megatrends, Inc.
KONTRON AT8050 BIOS Version 3.00
(C) American Megatrends, Inc.
64-3047-009999-00101111-031710-TYLSBURG-5007_300-Y2KC
Physical Processors Package: 1
Active Processors Cores: 4
Logical Processors: 8
Intel HT Technology: Enabled
QPI Speed: 5.866GT
CPU : Intel(R) Xeon(R) CPU L5518 @ 2.13GHz
Speed : 2.13 GHz
Reset Type: Cold Reset
Currently Running On Primary BIOS.
Press DEL to run Setup (F4 on Remote Keyboard)
Press F12 if you want to boot from the network
Press F11 for BBS POPUP (F3 on Remote Keyboard)
Initializing USB Controllers .. Done.
Memory Channel 0 DIMM 0 Size 2048MB
Memory Channel 0 DIMM 1 Size Not Installed
Memory Channel 1 DIMM 0 Size 2048MB
Memory Channel 1 DIMM 1 Size Not Installed
Memory Channel 2 DIMM 0 Size 2048MB
Memory Channel 2 DIMM 1 Size Not Installed
DDR3: 6144MB OK, Speed: 1066MHz
Auto-detecting USB Mass Storage Devices ..
00 USB mass storage devices found and configured.