Kontron AT8050 - Manual (Page 121)

Software Setup
105 AT8050
www.kontron.com
5.1.7.2 Set LAN Configuration sub-menu
5.1.7.3 IP Configuration sub-menu
Feature Option Description Help text
Channel Number 01 or 02
Each interface has a channel number that is
used when configuring the channel and for
routing messages between channels. Channels
01 and 02 on Base interface are available. The
channel number assignments are described in
IPMI Specification 2.0, table 6-1.
Enter Channel Number
for SET LAN Config
Command. Proper value
01 or 02.
Channel Status Valid or Invalid Display Valid if IPMC support LAN Channel. N/A, display only.
IP Address N/A Selects sub-menu.
Enter for IP Address
Configuration.
MAC Address N/A Selects sub-menu.
Enter for MAC Address
Configuration.
Subnet Mask N/A Selects sub-menu.
Enter for Subnet Mask
Configuration.
Gateway Address N/A Selects sub-menu.
Enter for Gateway IP
Address Configuration.
VLAN ID N/A Selects sub-menu.
Enter for VLAN ID
Configuration.
VLAN Priority N/A Selects sub-menu.
Enter for VLAN Priority
Configuration.
Active LAN Channel
Number
None
01
02
Both Each interface has a channel number that is
used when configuring the channel and for
routing messages between channels. The
channel number assignments are described in
IPMI Specification 2.0, table 6-1.
Enter Active LAN
Channel Number for Set
LAN Configuration
Command.
Feature Option Description Help text
LAN Parameter Selector 03
The parameter selector assignments are
described in IPMI Specification 2.0, table 23-
4. Selector #03: IP Address.
N/A, display only.
Channel Number 01 or 02
Each interface has a channel number that is
used when configuring the channel and for
routing messages between channels. Channels
01 and 02 on Base interface are available. The
channel number assignments are described in
IPMI Specification 2.0, table 6-1.
Enter Channel Number
for SET LAN Config
Command. Proper value
01 or 02.
Channel Status Valid or Invalid Display Valid if IPMC support LAN Channel. N/A, display only.
IP Address Source Static or DHCP
Select whether IP Address is set Static or
retreive using DHCP.
Select IP Address
Source: Static or DHCP
Current IP Address xxx.xxx.xxx.xxx
Display the current LAN configuration stored
in IPMI NVRAM for IPMI LAN.
N/A, display only.
IP Address xxx.xxx.xxx.xxx
This allows setting an IP Address for LAN
configuration when IP Address Source is set to
static. This option is hiden when DHCP source
is selected.
Enter IP Address in
decimal in the form of
XXX.XXX.XXX.XXX (XXX
less than 256 and in
decimal only).