Elecraft PX3 Owner's Manual - Manual (Page 47)

47
Locate the two tilt legs and six rubber feet. Mount one rubber foot on each tilt leg as shown in Figure 38.
The feet are held in place by friction. Be sure the feet are worked all the way onto each foot as shown.
Figure 38. Preparing the Tilt Legs for Installation.
Install a flat washer and black nylon screw on each tilt leg as shown in Figure 39. Note the orientation of
the screw as well as the rubber foot that you installed earlier. They must be as shown for the foot to work
properly.
Figure 39. Placing Nylon Bumpers on the Tilt Legs.
Unwrap the bottom panel and clean away tape or paint from each end as shown in Figure 40.
Figure 40. Rear Panel Ends Cleaned.