Elecraft PX3 Owner's Manual - Manual (Page 42)

42
Replace the LCD in the rubber matrix and lay the front panel board face up on your work table. Remove the
thin plastic film over the LCD using a sharp edge to pick up one corner as shown in Figure 28 and then peel the
plastic off of the LCD.
Figure 28. Removing the Plastic Film from the LCD.
Remove the plastic display bezel from its protective wrapping and inspect it for dirt and dust, especially on
the flat side that will face the display panel. Use a soft cloth if necessary to remove any objects clinging to the
plastic. Similarly, inspect and clean the face of the display. If either requires further cleaning see Cleaning the
LCD Bezel on page 50.
Look closely at the edge of the bezel and note that the edge is slightly beveled on one side (see Figure 29) .
This side will face away from the front panel.
Figure 29. Bezel Beveled Edge.