Elecraft PX3 Owner's Manual - Manual (Page 25)

25
Table 1. 160 – 6 Meter Band Amplitude and Phase Settings.
Freq.
MHz*
Initial Settings New Settings
Ampl. Phase Ampl. Phase
1.818
3.6
5.357
7.20
10.112
14.063
18.0
21.429
25.0
28.125
50.0
* The frequencies shown are those generated by the PX3 internal calibrator. Any frequency near the
middle of each band may be used.
Table 2. Transverter Amplitude and Phase Settings.
Transverter
Adr
Frequency
Initial Settings New Settings
Ampl. Phase Ampl. Phase
Only adjust those transverter bands you actually use. There is no benefit in adjusting the other bands.
The frequency is the center frequency transverter tuning range.