Elecraft PX3 Owner's Manual - Manual (Page 28)

28
Menu Functions
Tap M E N U and then turn the SELECT knob to scroll through the following list of menu functions. Tap the
SELECT knob to select the displayed function.
PX3 Menu
Entry Default Description
Cal Sig Off Enable/Disable Calibrator signal output.
CenterEn Off When OFF, the CENTER key does not adjust the center frequency.
Cursors Bar
Bar produces a full height translucent bar on the spectrum display. “U” produces a
U-shaped cursor at the bottom of the spectrum display.
DispTest Off
Shows a test pattern with a color bar and the complete character set of each font.
Tap
M E N U to exit.
Font 9 x 14 Changes the font size.
FN Erase N/A
Resets a function key to its un-programmed state. Tap or hold the function key to
be erased while this menu item is displayed.
Freeze Off
Freezes or un-freezes the current spectrum and waterfall display. This function is
most useful when assigned to a function key, which toggles between the frozen and
un-frozen state.
FW Rev N/A
Displays the main firmware version number. It is not necessary to tap the
SELECT knob for this function.
Knob Tap N/A When assigned to a function key, duplicates the SELECT knob’s tap function.
Knob Hold N/A When assigned to a function key, duplicates the SELECT knob’s hold function.
LCD Brt 100 Adjusts the display brightness from 0-100.
LCD Test Off Set all display pixels to white at full brightness.
Lvl Lines Dotted Select dotted or solid lines for the amplitude level graticule.
Lvl Mode dBm Select the amplitude level display units, either dBm or S-units plus dB over S9.
MKRA
zero
N/A
Resets marker A to the center of the screen.
MKRB
zero
N/A
Resets market B to the center of the screen.
NB En Off Turns noise blanker on and off.
NB Level 11 Sets the noise blanker level (see Noise Blanker on page 18).
OSB Ampl 0 Adjusts the I/Q amplitude balance (see page 24).
OSB Phaz 0 Adjusts the I/Q phase balance (see page 24).