Dynojet 250i: Installation Guide - Manual (Page 94)

Model 200i and 250i Motorcycle Dynamometer Installation Guide
C H A P T E R 3
Extended Carriage
3-28
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
EXTENDED CARRIAGE
The extended carriage option increases the maximum wheel base (measured from the
front of the front wheel to the center of the rear wheel) from 84 inches to 101 inches
for testing raked cruisers and drag bikes.
If you do not have the extended tire carriage with the bearing bracket, refer to
Appendix D for instructions on installing the extended tire carriage—discontinued.
To prevent possible injury, open the CPI door and set the main breaker to the
off position and unplug the dyno. Refer to Figure 3-1 on page 3-2 for breaker
location.
P ARTS L IST
The following table lists all of the parts included in the Extended Carriage
(P/N 71323003) Installation kit. Check your kit against the parts listed to make sure
you have received all of the parts. If any part is missing, contact Dynojet Technical
Support.
part number description quantity
21224105 Carriage Clamp Spacer 4
21224106 Nut Driver Spacer 2
21624700 Extended Carriage Strap 1
36580434 Bolt, 3/8-16 x 1/2", Button-head, Flange, Allen 4
36560836 Screw, 1/4-20 x 1/2", Button-head, Flange 6
36561670 Bolt, 1/4-20 x 1" Hexagonal 2
63310901 Tire Lock Assembly with Stickers 1
71323003 Extended Carriage Assembly 1
DM150-002-003 Bolt, 5/16 x 1.5" 4
DM150-002-004 Washer, 5/16", Lock 4
DM150-002-007 Washer, 5/16", Flat 2
DM150-002-008 Nut, 5/16" 6
DM150-016-004 Carriage Screw Bearing 1
DM150-016-005 Carriage Screw 1
DM150-016-007 Carriage Screw Support Bracket 1
DM150-053 Bolt, 5/16 x 1" 4
EXT100-207 Extended Carriage Support Bracket 1
The following part numbers are not included with the extended tire carriage
63310902
Tire Stop with Stickers and Strap - Yellow 1
DM150-016-006 Carriage Hand Wheel 1