Dynojet 250i: Installation Guide - Manual (Page 130)

Model 200i and 250i Motorcycle Dynamometer Installation Guide
C H A P T E R 5
Loading the Bike
5-2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
LOADING THE BIKE
Use the following steps to load a motorcycle on the dyno.
Keep the motorcycle balanced while driving on and off the dyno.
Risk of injury. Always wear proper eye and ear protection when operating the
dyno.
1 Load the bike on the dyno.
2 Place the bike on the dyno so the front tire is in the tire stop.
3 Strap the front wheel to the tire stop and tighten or use the control panel to run
the wheel clamp closed.
Never perform a dyno run if the tire strap is not in place or is damaged.
4 Turn the carriage screw handle (or use the control panel to run the power
carriage) until the rear axle is aligned with the center of the drum.
5 With the motorcycle in neutral, align the wheel in the center of the knurl by
pressing the dyno starter switch.
Figure 5-1: Align the Wheel and Axle
tire stop
tire strap
adjust carriage to align
rear axle with drum
center drive axle on
dyno drum