Extended tire carriage-discontinued, Extended tire carriage—discontinued – Dynojet 250i: Installation Guide User Manual
Page 174
Model 200i and 250i Motorcycle Dynamometer Installation Guide
A P P E N D I X E
Extended Tire Carriage—Discontinued
E-6
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
EXTENDED TIRE CARRIAGE—DISCONTINUED
If your tire carriage does not have the bearing bracket, you will need to use the
following directions. Refer to page 3-29 for instructions on removing the standard tire
carriage.
I
NSTALLING
THE
E
XTENDED
T
IRE
C
ARRIAGE
S
UPPORT
B
RACKET
1
Loosely attach the extended carriage support bracket to the front of the dyno
using six 3/8-16 x 1/2-inch button-head flange allen bolts.
2
Using a straight edge, line the top of the support bracket with the top of the dyno
chassis.
3
Tighten all six screws.
Figure E-6: Install the Extended Carriage Support Bracket
extended carriage
support bracket