Dynojet 250i: Installation Guide - Manual (Page 54)

Model 200i and 250i Motorcycle Dynamometer Installation Guide
C H A P T E R 2
Routing Cables
2-32
R OUTING THE P OWER C ARRIAGE AND W HEEL C LAMP C ABLES
The power carriage and wheel clamp are optional accessories. These cables will only
be used if you ordered the accessories.
For installation instructions refer to “Power Carriage” on page 3-42 and “Wheel
Clamp” on page 3-47 for more information.
1
Remove the two screws securing the cable pass through cover on the front of the
dyno and set aside.
2 Locate the cables bundled inside the dyno.
3 Route the power carriage and wheel clamp cables through the opening in the
front of the dyno.
Figure 2-33: Remove the Cable Pass Through Cover
route cables
through
cable pass through
cover