Dynojet 250i: Installation Guide - Manual (Page 58)

Model 200i and 250i Motorcycle Dynamometer Installation Guide
C H A P T E R 2
Tire Carriage Installation
2-36
6 Starting from the back of the dyno, slide the carriage under the carriage clamps.
7 Slide the carriage screw and the bearing bracket toward the nut block until the
carriage screw is touching the nut block.
8 Slide the hand crank onto the end of the carriage screw.
9 Secure the hand crank to the screw shaft by tightening the set screw using a
5/32-inch allen wrench.
10 Using the hand crank, screw the carriage through the nut block and into the
screw support bracket.
11 Secure the bearing bracket to the carriage using four 1/4-20 x 1/2-inch
button-head flange bolts removed earlier.
Note: If you ordered the power carriage accessory, refer to “Power Carriage” on
page 3-42 for installation instructions.
Figure 2-37: Install the Tire Carriage and Secure the Hand Crank
DC031
hand crank
carriage
bearing bracket
carriage screw
nut block