Dynojet 250i: Installation Guide - Manual (Page 46)

Model 200i and 250i Motorcycle Dynamometer Installation Guide
C H A P T E R 2
Dyno Electronics
2-24
The standard dyno electronics is located inside the dyno electronics enclosure which
is already mounted to the dyno chassis as shown in Figure 2-24. Cables which you will
route in the next steps are prewired to the dyno electronics or to the CPI. You will
connect the free ends of the cables to the appropriate devices.
Figure 2-24: Location of Dyno Electronics
MC120
cables are pre-attached
to the dyno electronics
located inside the
dyno electronics
enclosure
dyno electronics
enclosure
dyno electronics
enclosure
CPI